Call us at 1-877-223-8858 or Ask a Question below

This beautiful vintage Neumann M250C represents the epitome of tube microphone design. Neumann’s M 250 is an omnidirectional tube mic based on the chassis and amplifier of the multipattern M 49. The primary difference between the two was the innovative capsule used in the M 250. It also should be nothed that the M250c is identical to the M50c, excepth that the M250c uses a 7 pin Tuchel connector for better EMI/RF rejection.

Tech Notes:  MOGAMI cable.all original capacitors on microphone.AC701 s/n 15063 U4102500 mic set to 200ohm  PSU recapped with 105C capacitors.carbon box no peli case. Light bulb + cover on PSU missing

The M250 used a small omnidirectional transducer mounted on a 4cm-diameter acrylic sphere, such that the diaphragm of the capsule lay flush with the face of the sphere. Because sound flows differently around a sphere than around other surfaces, the microphone’s frequency response is altered by this capsule construction.

Specifically, the M250 had a smoothly rising frequency response that looks nearly like a high-shelf EQ set to +5dB above 2500Hz.

The value of this response characteristic is beautifully explained by Stephen Paul in his classic survey of vintage mics:

Stephen Paul

High frequencies roll off as the square of the reciprocal of the distance from the sound source due to frictional effects. This means that the viscosity of the air is sufficient to dissipate sound energy in the form of heat, and as there is less power in the treble range, it suffers the most from this effect. Therefore, when a mic is hung high above an orchestra in the auditorium, a boost in the response above 5 kHz is desirable. Even today, these microphones still make some of the most wonderful orchestral recordings in the world.

Related to the effect of the rising frequency response is the directional characteristic of the microphone. Simply put, the mic — although technically speaking still an “omnidirectional” — is more directional at higher frequencies.

Neumann

The unique feature of the microphone is its high frequency directivity, similar to that of a pressure gradient type, combined with the linear response at low frequencies, well-known for pressure microphones.

Neumann changed components in the M250 several times during its production run from 1951–1971, although not all of the changes were indicated by a model-number designation. The following details are taken from Martin Schneider’s AES presentation on spherical omni microphones :

M 50, 1951: The first commercial release used a Hiller MSC2 tube and a PVC-diaphragm KK50 capsule. According to Neumann’s Martin Schneider, the PVC material was not well suited to the “extreme mechanical tension” required.

M 50a, 1952: the ‘a’ version indicated a capsule change, from KK50 PVC to an aluminum-diaphragm KK53.

1954: the MSC2 tube was replaced with a Telefunken AC701. (This tube/capsule combination was reproduced in the KM53, a tube omni pencil mic.)

M 50b, 1963: “a negligible change, of resistor power ratings.”

1965: The KK53 capsule was replaced with the Mylar-diaphragm KK83.

M 50c, 1965: the “filament topology” of the amplifier circuit was changed, lowering the self-noise by 4dB.

Anselm Roessler

This microphone was, however, extraordinarily difficult to produe and the rejection rate was enormous, so production was halted in 1971.

The concept of altering an omnidirectional condenser transducer’s frequency response by embedding it into a Perspex sphere originated with the NWDR (Nordwestdeutscher Rundfunk) Laboratory, which was Northwest German Broadcast’s research institute, under the direction of Herbert Großkopf.

Neumann has since released the TLM50, a transformerless interpretation of the spherical-omni-capsule concept.

The M 49 and M 50 shared a case and grille design — the grill employs Neumann’s traditional 3-layer metal mesh with a slanted, flattened face. The only visible exterior difference between the two mics is the color of the “jewel” above the Neumann logo on the body. On the M 50, the bead is white. On the M 49, the bead is red.

This vintage, all original microphone includes original power supply . Also includes the mounting yoke, and the original wooden box.

JUST SEEN

Search

Just added to your cart:
Qty:
Total:
Subtotal:
Excl. postage 
My Bag
Just added to your wishlist:
Excl. postage 
My Wishlist